He noticed it anyway. He pressed his hand flat against the section. It was cold in the way sealed spaces are cold. He spent 20 minutes finding the access point.
There was no visible door from the main interior. He went outside, paced the exterior wall, and calculated the space that should have been there. Then he came back in and ran his hands along the bottom of the wall segment until he found a steel channel set flush with the floor. The door was not locked.
It had been sealed. A mechanical bar set from the interior, but the bar had corroded into place rather than being locked deliberately, and Ethan had brought the right pry bar for general clearing work. It took 7 minutes, and his right shoulder was sore afterward. But the door came open.
The air that came out was not musty. It was dry. Climate-managed dry, the kind of dry that requires deliberate engineering. He stood in the doorway for a moment.
Then he found the light switch on the interior wall, a simple toggle, and he half expected nothing, and the fluorescent tubes flickered on in sequence. There were 10 automobiles. They were spaced in a row along the length of the interior, each covered with a fitted canvas numbered with hand-painted aluminum tags on the covers, C1, C2, C3. He walked along the row without touching anything.
The canvas covers were clean, not new, but maintained. The floor was sealed concrete, unmarked by rust or oil. He stopped at C1 and stood in front of it for a full minute. Then he pulled the corner of the cover up.
The frame underneath was light—not automotive light, aircraft light. He had been an aircraft mechanic for 15 years. He knew the difference in the feel of metal, the weight of a component in your hand versus what it should weigh if it were built for road use. He lifted the cover completely.
The body was low, narrow, and built from materials that made no sense for a passenger automobile. Magnesium alloy over a tubular space frame. The suspension geometry was wrong for normal road dynamics. It was optimized for something else.
He crouched beside the wheel arch and looked at the machining on the hub assembly. It was not mass production. It was handwork. Precision handwork.
The kind that takes three times as long and costs five times as much. Done by someone who had been making the part for the first time and was figuring it out as they went. He checked C2, different body style, same structural philosophy. The machining marks were different, a different hand.
He crouched again, comparing the two hub assemblies side by side. Two different people, same project. He checked C3, C4. The alternating pattern repeated.