The third thing I saw was the oil scavenge pump bracket on the lower left side of the engine bay, partially obscured by the wiring harness. It was hand fabricated. The geometry was not factory. The welding signature was not factory. The bracket angled approximately 7° forward from where a stock bracket would sit, which was the specific compensation pattern that one fabricator in Weissach had used between 1997 and 2014 to optimize oil scavenge under sustained high G cornering.
Heinrich Miller. I bent down to confirm what I was already certain of. There was a small stamp at the lower edge of the bracket, partially covered by a film of clean oil residue. I took out a microfiber cloth from my pocket and wiped the bracket once. MR04 Manthey Racing Internal mark, Heinrich's series number four.
He had only made seven of these brackets in his entire career, outside of Mantis' official production line. Each one was a personal project. Each one was for a car he had personally rebuilt. I knew this because I had been there for two of them. I held my position for a moment longer than I should have.
I could feel my breathing slow down on its own. My hands were not shaking, but they had become very still in the way they used to become still when I was working on something at Le Mans in 2014 and a senior engineer was watching. Behind me, Vivian said, "Did you find something?" I straightened up. I closed the engine cover most of the way, but did not latch it. "I need to ask you a question.
When did your father buy this car?" She paused. "Why?" "Because I need to know whether the car was already restored when he acquired it or whether he had it restored later." "It was already restored. He bought it in 1991 from a dealer in Frankfurt. He kept it in Germany for some years before importing it." "Why does that matter?" "It matters because someone has been inside this engine bay in the last 18 months and replaced a component that should not have been replaced." Preston Vance shifted his weight. "I noticed it the way you notice changes in pressure when a door opens in another room.
Small, specific." "Replaced with what?" Vivian asked. "With a modern aftermarket part that doesn't seat correctly against an original modification that's been on this engine since at least the mid-1990s. That mismatch is almost certainly what's causing your misfire and pressure loss. The car runs fine until thermal expansion brings the new part out of alignment with the original bracket, which usually happens around 80 to 100 miles of sustained driving." Vivian looked at me, then at Preston, then at the car. "How long would it take to fix?" "To diagnose properly and confirm, 2 days, to source a period correct replacement and install it, another day.